This is a micro scale RC airplane designed to essentially snap together from common hobby store supplies. It can be assembled with the aid of a little superglue reinforcement in under 20 min post printing.

VIDEO: https://www.youtube.com/watch?v=Q2kgXI0ZaCQ&feature=youtu.be

Printed using Tough Resin on a Form 1, I'm fondly calling her the 'Air-Form 1.'

It took 3 design iterations but this final version is a superb flyer. weighing roughly 60 grams, she is a micro plane but the dihedral wing make her very stable even in a couple kts of breeze.

The motor mount/gearbox, wing clamp, and both the rudder and elevator hinges and clips were all printed out with tough resin. The main body is a rectangular carbon fiber rod and the wings are 2 rectangular balsa sheets. The motor and gearing is a replacement motor/geartrain for a laTrax quadcopter. The receiver is a specktrum ar6410

battery: 150mAh thrust: 54g weight: 60g wingspan: 58cm dihedral: 15deg flight time: 11min

Non-Printed Parts: specktrum ar6410 150mAh battery laTrax motor laTrax bearings laTrax gear/propshaft laTrax prop 3/32in X 7/32in X 3ft rectangular carbon rod 3/16in carbon tube 7/64 carbon rod 3ft X 3in X 3/32 balsa board 1/32in music wire superglue

I'm hoping to add landing gear in the future!