A great little trophy for golf events or friendly competitions. Can also be used as small gift for any passionate golfer.

At standard scale the ball is approx. to true 1:1 size and the 248 dimples are close to those on an average golf ball. Printed at standard scale the trophy is 97mm high and 55mm in diameter.

Print in one colour or pause to change the filament and make it multi-coloured (refer images). Colour change points at standard scale with a 1mm Raft are:

Colour One: 0mm - 24mm

Colour Two (Green): 24mm - 28mm

Colour Three: 28mm - End / 59mm (if you decide to make the Tee a different colour as well)

Colour Four: 59mm - End

Refer to the instructions for print settings as this will help ensure a good result and the Tee is strong enough.

The file is quite large due to the detail in the dimples on the ball surface... but well worth the download. If you're a golfer you will appreciate this, if not. but you know a golfer, print one as a gift.

Note: If you like this check out all my other designs!
.

Recommended settings are:

• Raft On
• 0.20mm Resolution (Std.)
• 4 Shells (3 works okay on some machines but 4 is recommended for strength during printing as well as when its being handled once finished)
• 20% infill (Again, this adds strength to avoid being broken when handled)
• No Support

Print in one colour or pause to change the filament and make it multi-coloured (refer images). Colour change points at standard scale with a 1mm Raft are:

Colour One: 0mm - 24mm

Colour Two (Green): 24mm - 28mm

Colour Three: 28mm - End / 59mm (if you decide to make the Tee a different colour as well)

Colour Four: 59mm - End