Needed a stand to angle my projector for some mapping projects.  This one was designed to work with an Optoma but is generic enough to fit other brands.  It's designed so you can use it with a bunch of different angles by putting the projector in forwards or backwards or bending the front or back legs up and down.

A simple, low-profile projector stand designed to elevate your projector slightly for better airflow and improved positioning.

This stand provides stable support without adding bulk, making it perfect for shelf or desk setups where you just need a small lift rather than a full mount. The open design helps with ventilation while keeping the footprint minimal.

⚙ Features

• Low-profile riser design

• Improves airflow under the projector

• Stable support with minimal material

• Clean, simple geometry

• No assembly required

🖨 Print Settings

• Supports: ❌ Not required

• Raft/Brim: Not needed

• Infill: 15–25%

• Walls: 3 perimeters recommended

• Layer Height: 0.25 mm

• Material:

  • PLA (works great)

  • PETG (recommended for heat resistance)

📐 Orientation

Print flat on the build plate (default orientation).

📏 Notes

• Works with most small to medium projectors

• Can be scaled to match different device sizes

• Helps reduce heat buildup under the projector

🧩 Use Cases

• Improving airflow and cooling

• Minor height adjustments without bulky stands

💡 Tips

• Increase wall count if supporting heavier projectors

• Use PETG if your projector runs warm