There are lots of phone stands out there but I found that most were not made to account for a Pop Socket or other attachment on the back of the phone and would not sit flat when used with one. So I have made a simple phone stand with a cutout that will fit a Pop Socket with the phone either horizontally or vertically. I'm assuming most people will have their attachment centered on the back of their phone, but there is some wiggle room around the cutout and once the Socket is in the groove, it keeps the phone from sliding away so it can work with off centre attachments as well. It can also hold your phone with the Pop Socket extended to allow for easy pickup and put down while working.

The stand prints very easily by flipping it on one side and the edge of the cutout is chamfered so it can print cleanly without any supports.