A stand to hold a set of eight hex keys of sizes 2 to 10.

This was designed to fit my set of Workzone keys and the hole depths have been created as such. The F3D file has been provided to enable you to adjust it as required for your own sets if needed. The tolerances are also quite tight (about 0.2mm) so adjust accordingly for your printer.

The model pictured is printed in Bambu PLA Metal Iron Grey (13100) with a slight fuzzy texture on the outside to give it a ‘cast metal’ look.

This does take about 400g of filament with 15% adaptive cubic infill so be sure to check fit and tolerances before printing to avoid disappointment.