Helping Hand LED mount

This is a mount for a 12v G4 LED replacement lamp module
( [https://www.amazon.com/dp/B085XTRPGV](https://www.amazon.com/dp/B085XTRPGV) )
that will fit on the end of a 1/4" NPT flexi-hose coolant pipe, commonly used to construct "helping hand" soldering aids.

Print Settings

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2

Infill:

20%

Filament:

any PLA+ or PETG any

Notes:

The lamp shown did not exhibit any significant heating after running 20 minutes @ 13.8v, so material choice is pretty open.

I printed this upright (the pipe mount against the bed) using tree supports and a support blocker for the center portion encompassing the pipe mount.

This mount should snap onto the pipe end after removing the nozzle.

Category: Electronics

Descrição

Print Settings