Our goal was to create a modular bin system that would allow us to display small 3D Prints at shows and also be visually appealing. The HexBin system currently has a small and large version. For each size there is a bottom base, lid and angled riser. You will need to print two of the risers for each box that you want to raise up at an angle. The HexBin will stack without a lid, allowing you to prepare for a show quickly. If you prefer, you can continuously stack bins with the lids, as they have a ridge to hold the next bin on top.

Please note that the top does have a tight tolerance to allow the lid to grab. You may need to adjust for your printer.

We printed most of ours with a 5% gyroid infill .20 Layer Height.