Hello gals and guys!

I was thinking about creating my own Minecraft tools keychain. Because some of the models from my point of view, were small, fragile.. or not similar to Minecraft pixels or composition. SO I decided to create and print test my own. 

After some struggles and print tests.. I created optimal size which can not break easily and the circle of keychain can be inserted easily. It is in optimal ratio to your keys! 

I used rings of diameter 0,7cm and big primary ring for keys 2,5cm.

If you are a BAMBU user, I put also files with colored models. 

Hope you guys like it and print test it! Also I am grateful on any comment and suggestion! You are free to remix my models!

Also show me pretty please your photo of prints! :3

3D print setup ( pretty much you can use your own setup.. there is nothing special in this print settings ):

Nozzle

0.4mm

Layer height

0.12mm

Wall thickness

1.2mm

Infill

10%

WITHOUT SUPPORT