This is a little case I designed for the Pimoroni hyperpixel round and raspberry pi zero.

To assemble you'll need:

• 4 3D Printed Parts from the attached STL
• Pi Zero (or Zero 2)
• Pimoroni Hyperpixel Round
• SD Card with Raspian image
• 4 M2.5 spacers (xmm)
• 4 M2.5 x 5mm screws
• Right Angle Micro USB to Micro USB Female Cable

Screw the interface plate, Pi and screen togeather

Insert SD Card and USB cable and place assembly into the main case

Route cable out the back and snap on the base

Press the cover ring into place (print in a contrasting colour for a bit of pop).