This is a very simple customizable cable clip modeled in OpenSCAD. Use it to neatly route cables around your house and projects. Can be used with screws and nails, just adjust the hole size to your requirements.

It takes less than 4 minutes to print one, probably far less depending on your setup. I recommend printing extras to be prepared for the next job. Best printed lying on their side for optimal strength.

Pre-exported STLs available:

• 4mm
• 5mm
• 6.5mm
• 7.2mm
• 7.5mm

If you want to customize them but don't have OpenSCAD installed, don't fret! You can use this link to customize them in your browser! No need to create an account, just enter your desired values, press “play” at the top, and export your STL.

If you have ideas for improvements, leave a comment and I'll see what I can do.

I'm thankful for any makes and likes, it shows my work has helped you out there. Happy printing!