I did not find a photo studio stand that fits for my needs, so i designed this one.

It is easy to print and modular for different paper sizes. I used a white cardboard, that was the backside of an old wall calendar.

Parts

For a DIN A4 paper you will need: 

• 1x left part + 1x right part
• 0x middle part (optional as much as you like)
• 2x connector rod
• 4x secure pins (optional 4x per additional middle part)

For a DIN A3 paper you will need:

• 1x left part + 1x right part
• 1x middle part (optional as much as you like)
• 4x connector rod
• 8x secure pins (optional 4x per additional middle part)

You could go even bigger if you have that paper, of course.

Printing

PLA and 15% Infill is fine. No support structure needed.

Just make sure to use a brim for the side and middle parts!

Assembly

Assemble it completely except of one side part as you can see on the second picture. Then carefully slide the paper into the slots and connect the remaining side part.