Modular tomato cage for helping your tomato plants stay upright! The ring is 12" and the legs are 6". They are full modular/stackable, you can start with one and add more as your plant grows. The circle has notches to fit the legs.

I extended it off an existing cage I had, as you can see in the picture, but it is also fully modular with itself.

Recommend you use ASA for outdoor use, but you can probably get away with PLA.

Printer settings I used, it seems sturdy enough but you can always increase density for more stability:

• Layer height: 0.2mm
• Infill: 15% grid

Rev 2 has adjusted notches in the feet so they're less likely to snap and fit over the ring notches better.