This rack was designed to clear off my desk. Full freecad sources are included.

This rack can be mounted to the underside of your desk with 4x #6 screws of your preferred length. Otherwise no additional hardware is needed.

Parts should be printed flat side down with supports on build plate only. The bottom plate should be printed with 0 top/bottom layers and 6 shells minimum.(Or just print it regular if you don't want exposed infill). Parts should all snap together if your printer can print to reasonable tolerances, but some minor sanding may still be needed.

Note that the headphone hook has been moved down in the released models to avoid bumping the underside of the desk with thicker headphones.

Make sure to check out my schiit box project box if you need to add non-schiit devices to your stack rack.

[https://www.printables.com/model/815937-schiit-box](https://www.printables.com/model/815937-schiit-box)