This is a fully 3d printable poker chip set. The holder is capable of holding 200 chips. I recommend printing the chips with as much infill as possible as they will have a much nicer weight, but any infill will do.  Please note that if your filaments are tuned differently some may end up thicker than others, which can be seen in the last image with the green chips. I have added some indents into the lid to amend this.

Each slot holds 20 poker chips

Poker Chip Settings:

no specific filament needed.

0.2mm layer height

Some kind of circular top/bottom surface pattern recommended as it looks nicer (concentric or Archimedean)

any infill, 100% recommended

Poker Chip Holder Settings:

0.2mm layer height, no supports