Triangular LED Strip Now Playing Record Stand

This is a record stand I created with a few special features. It is designed to use two metal 4mm rods inserted in the back for stronger support. It is also designed to hold a small light strip inside the front to illuminate both the "Now Playing" sign and the record cover it's displaying with a spotlight effect.

Print Settings

Printer Brand:

FlashForge

Printer:

Adventurer 5M

Rafts:

Supports:

Infill:

Notes:

Recommendations

No supports are necessary.

4mm x 200mm metal rods are what I use for the back supports, they should fit snugly with a little bit of force. I also use rubber tips on the top because the rods I purchased were a little jagged on the ends. Technically you could also print the rods but of course metal would be stronger. If there are requests I will create an STL for printable rods.

Add more walls and infill to make it stronger. There is enough space to stack a bunch of records but the weak point is where pillars meet the bottom of the stand, especially if there are a lot of records leaning against it.

Print in a semi translucent color, otherwise the light will not pass through the letters. However the spotlight in the back will work either way.

I use light fuzzy walls settings to avoid layer lines.

Category: Music

Descrição

Print Settings