This is a custom mount for an Offgridtec 20W solar panel. I created this mount because I wanted to install the panel at a 30° angle in my front yard.

The design is tailored for the Offgridtec panel but can be easily adjusted to fit other panels as well.

It's highly recommended to use PETG or a similar material to ensure sufficient strength and UV resistance in the mounts.

When printing, orient the mounts on their side to avoid the need for supports.

Once printed, position the mounts against the side of the panel and drill four holes into the aluminum frame. Secure the mount using M5 screws.

Print Settings

• supports: no
• layer height: 0.3mm
• infill: 100%
• material: PETG