Designed a container for my partner who loves pineapples. The body of the pineapple is designed from scratch, the leaves are copied from The Pineapple right here on Thingiverse.

Printing

Scaling to 84% makes a container that holds roughly 550ml, perfect for holding tea. Say green lemon pineapple rooibos. I used tree supports in Cura, only to buildplate, should be a minimal ring of supports on around the bottom. The inside is designed to be printed without supports.

Finishing

Might need slight sanding for the lid to fit flush, depending on tolerances of your printer.

Remember to use food-safe materials if you're putting food (like tea/coffee) in this.

Print Settings

Printer Brand:

Prusa

Printer:

Yes

Supports:

0.2mm

Infill:

Notes:

Category: Containers