The original IKEA Skådis hooks can be a pain, especially if you put something on them that grips slightly, like a pair of pliers. Once you lift the pliers, the hook comes loose since you'll never lift exactly vertically.

That's why I made these hooks that snap into place on the IKEA Skådis pegboard.

In addition to the satisfying “click” of it snapping into place, you also get a button to push when you want to dismount it. Yay!

No supports needed. I had great success with thin layer heights like 0.10mm but 0.20mm should be fine.

Use the base STL to create your own hooks. Note that there's a slight angle to compensate for the deformation, so make sure you align them properly.