Last year the bugs were able eat a bunch of my strawberries, not this year! While preparing the greenhouse for spring planting, I was surprised to find that a few of my strawberry plants were already flowering. Last year I tried a net trellis with some success, however the bugs still got too many of the delicious strawberries. I wanted to try something different this year and decided to make some strawberry supports.

I placed these on plants that had been planted in previous years, it should be easier to place them with new plants.

I recommend letting the build plate cool for a few minutes before attempting to remove to prevent accidentally damaging the print. PETG will provide better protection against UV rays. I printed these in PLA this year and will replace them next year if needed.

Sizes

Full size

• 224mm W x 224mm D x 80mm H
• 8.8" W x 8.8" D x 3.1"H
• Center Diameter - 80mm (8.8")

Mini Size

• 174mm W x 174mm D x 80mm H
• 6.8" W x 6.8" D x 3.1" H
• Center Diameter - 62.4mm (2.5")