Type: Vekoma

Scale: 1:32

Size: ~ 56 cm x 32 cm x 18 cm

Printer: Original Prusa i3 MK3S+

Settings: 0.2 mm / 30%

Filament: 259 g (Footers: 46 g, Supports: 67 g, Track: 146 g)

Print Time: 32:53 h (Footers: 4:30 h, Supports: 8:08 h, Track: 20:15 h)

Difficulty: Easy

Instructions

I recommend using 1.2 mm wire to assemble the track. This makes the track more stable and easier to assemble. But it also works without wire.

Attention: Some of the individual parts are almost identical. But it is important to put them together in the correct order.

General information

In the following steps, you will always find a list of the parts that are needed for a section. You should be able to assemble the supports without instructions. For the rail sections, it is important to assemble them in the correct order. R01-P01, R01-P02, R01-P02, ...

Here you can see the basic structure of a rail section. For the assembly I recommend 1.2mm wire. But it works also without.
Note the orientation of the connection part for supports. It has a small arrow (B) on one side. This must point in the same direction as the connector of the rail.

The connectors of the rails always have a recess (A) on the upper side.

Footer 01

You will need this footer twice for the loop.

You need:

• 1 x Footer-Rail-045

Support 01

Print all the required parts and assemble them. Use glue to assemble the individual parts. You will need this support twice for the loop.

You need:

• 1 x Footer-Support-045
• 1 x S01-P01 - S01-P02

Support 02

Print all the required parts and assemble them. Use glue to assemble the individual parts. You will need this support twice for the loop.

You need:

• 1 x Footer-Support-055
• 1 x S02-F01
• 1 x S02-P01 - S02-P05
• 1 x Support-Plate-045

Track 01

Print all the required parts and assemble them as shown in the picture. Use wire inside the tubes and glue to assemble the individual parts. You will need this track section twice for the loop.

You need:

• 1 x R01-P01 - R01-P10
• 1 x Track-SupportConnector
• 1.2mm Wire (optional)

Track 02

Print all the required parts and assemble them as shown in the picture. Use wire inside the tubes and glue to assemble the individual parts. You will need this track section twice for the loop. Do not use R02-P09 yet!

You need:

• 1 x R02-P01 - R02-P08
• 1 x Track-SupportConnector
• 1.2mm Wire (optional)

Completion

To complete the loop, use R02-P09 to connect the two upper track sections.
The track should stay in place without using glue.

You need:

• 1 x R02-P09