Kitchen hook which mimics the look of the original overpriced chrome-ones. The wall storage rail was bought years ago in Bauhaus (if I remember correctly) and the rail has a diameter of 16 mm.

Printing tips:

• PETG, 0.15mm layer height.
• For 0.00-0.30mm height I set layer height 0.1mm to improve the overhang when printing the cylinder shape of the hook.
• PrusaSlicer warns about low adhesion to the sheet (because the first layer area is small), but with applying 3D lac on smooth sheet I didn't have an issue. But you may want to add a brim.