Toroidal Windmill - Self adjusting turbine

Looks like a spinning flower and no much wind is needed.

Information about model maintenance: Due to the considerable administrative effort involved in managing models across different platforms, I have decided to maintain only the original models on MW going forward. Thank you for your understanding.

YouTube Short

• Beautiful Windmill with toroidal Propeller Blades

• Self adjusting to wind direction through the tail blade

• 100% printed, no Screws or tools needed

• You can add 3 Propellers on one Axle with 2 distances

• Full customizable with different propeller sizes and directions (I plan to add more cool propeller types as well)

• Rods are stack able to your needed height

• Added custom support to the horizontal printing rod

• Added some “Slower” Propeller Blades 

Printing:

Files has the recommend print orientation.

For Propeller set wall generation to Arachne mode and set walls to 0,7mm 

The rod could be a bit difficult to print, i added custom support, but clean your buildplate and apply some glue.

PETG & PLA tested👍

Assembly:

Info:

The Pitch from the Basic Blades:

• Big - Pitch 195mm

• Med - Pitch 170mm

• Small - Pitch 135mm

Thanks to all followers and don't forget the virtual handshake 👍 ….Happy Printing

You can combine propeller blades with Honeycomb Windmill: [https://www.printables.com/model/807216](https://www.printables.com/model/807216)

Checkout this Clamp for Windmill , as well 🧐

Commercial license and more Mods like:

you can get here:

[https://www.patreon.com/BamBamDesign/membership](https://www.patreon.com/BamBamDesign/membership)