Some people have noticed that the orginal clips were wiggling loose so I added some roud knobs to the inside of the clips to help give them some bite when putting them on.

Instructions

This is a modification of the side panel clips by etron [http://www.thingiverse.com/thing:23636](http://www.thingiverse.com/thing:23636)

I added some little knobs on the inside to help it not slide off.

It is used to replace the nuts and bolts used with the Replicator hood kit to give it an even cleaner look and feel.
[http://www.thingiverse.com/thing:23386](http://www.thingiverse.com/thing:23386)

Category: 3D Printer Parts