Cooling tower ultrasonic atomizer

Recommended for tower print is stone or concrete-textured filament. For inner parts, I used phosphorescent material for a stunning glow effect in the dark. Additional ultrasonic atomizer (mist generator) is required for printing, such as this one: [https://allegro.cz/nabidka/ultrazvukovy-generator-mlhy-zvlhcovac-vzduchu-mlhy-pro-jezirko-zahradu-15092757286?utm_source=notification&utm_medium=cartWithPaymentCz&utm_campaign=fd8eae09-a77e-4400-bc26-84bdf1c5e8ec](https://allegro.cz/nabidka/ultrazvukovy-generator-mlhy-zvlhcovac-vzduchu-mlhy-pro-jezirko-zahradu-15092757286?utm_source=notification&utm_medium=cartWithPaymentCz&utm_campaign=fd8eae09-a77e-4400-bc26-84bdf1c5e8ec) . The showcased model used a 0.6mm nozzle on an older Prusa printer, with a layer height of 0.15mm. No supports were used in printing. The model can be connected to a smart electrical outlet with a timer setting. Since water heats up in the tower, it's advisable to run it intermittently. The rising steam is excellent for humidifying the air but may impact electronics. I recommend placing a tray or moisture-resistant mat under the tower for added protection. The model's usage is entirely at your own risk. :)