This is a cat themed yarn spindle/spike created in Tinkercad, sliced with Anycubic's Slicer, and Printed on my Kobra 2 Plus.

I printed using a 20% honeycomb infill, .2mm Layer height, Print temp was 215C, 1.75mm PLA for material and no supports were needed. 

PLA Used: Anycubic Black PLA

**Please share your prints and let me know what you think. This is was mostly a project to dip my toes into messing with Tinkercad but hope it might help someone looking for these yarn spindles because I didn't see a lot available.