I liked the Sasquatch light switch cover by JcDenton but I wanted one that would go over a toggle switch. I combined this with a toggle light switch to get the item I needed. This will be for my brother-in-law because he loves Sasquatch.

Make sure you enable supports in your slicing program and print with the front of the switch cover up.

You can see a link to the original light switch in the "remix from" in the bottom right.

Filament is Just PLA's black: [https://www.justpla.com/pla175mm/black-pla175-1kg?limit=100](https://www.justpla.com/pla175mm/black-pla175-1kg?limit=100)

Edit 1/4/20: I edited this light switch so it is a double light switch with sasquatch center for BeardMan21

The file is here if anyone wants to edit it: [https://www.tinkercad.com/things/c45QIEH1GQF](https://www.tinkercad.com/things/c45QIEH1GQF)

Print Settings

Printer Brand:

Wanhao

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Notes:

I enabled the supports option in cura. You want to print it with the front of the light switch cover facing up. That way when you attach the switch cover to the wall, Sasquatch sits flush up against the wall.

Post-Printing

I did not do anything other than remove the supports that were generated for the switch cover.

How I Designed This

I made this in Tinkercad using JcDenton's [http://www.thingiverse.com/thing:1537902](http://www.thingiverse.com/thing:1537902) Sasquatch light switch.

I also used TheNewHobbyist's [http://www.thingiverse.com/thing:47956](http://www.thingiverse.com/thing:47956) (wall plate customizer) to create just a single toggle light switch.

Category: Replacement Parts