A box and lid for holding up to 40 microscope slides meant to be printed in vase mode.

Fits on most 3D printer build plates.

Not recommended for use with samples that suffer from atmospheric, UV, or plastic exposure.

There are two lids: “tight” and “tighter” depending on the fit you'd like the lid to have. I personally recommend “tighter” but the exact fit will depend on your printer.

As always, any and all feedback is welcome and remixes are encouraged.

Print Settings

Spiral vase: on

Layer height: 0.20mm

Box

Print time: 3h34m

Used filament (g): 29.82

Lid

Print time: 1h29m

Used filament (g): 14.48