Simple, no-frills holder for game/DVD/Blu-ray cases. f3d file is included so that the parameters can be adjusted to suit your needs. All the included 3mf's have an outer width of half an IKEA kallax square (167.5mm), so that two side by side would fit perfectly in it.

If you'd like to save some time/material, these can also be printed in vase mode. It'll feel a bit less sturdy, but if it's sitting on a shelf it shouldn't matter too much.

These are the parameters that can be adjusted:

• outer_width - width of the total finished part
• case_width - width of a single game case (from spine to front)
• case_depth - thickness of a single game case - this is how wide each slot will be
• min_wall_thickness - sets a minimum width of the material between each slot. 1mm by default, can be tweaked as needed to get it to look how you want

These are the case size parameters I used for the included files:

• PS5/PS4 - 15mm x 135mm
• Switch - 11.5mm x 104mm
• 3DS - 13mm x 135mm
• Steelcase (for the thicker steelcases I happened to have) - 17mm x 135mm