Decided to make a sturdy tripod that is small, lightweight and that can hold a DSLR/Mirrorless camera.
The tripod requires ball head in order to be used properly with a camera as it legs uses hard stop to stay open. It does not support middle stops of the legs - it has to be used on quite leveled surfaces.

Available are two options for the base - 1/4 and 3/8, depending on the ball head or the equipment that you are going to use.

You will also need:

• 3 pcs of M4x35mm DIN 912 bolts.
• 3 pcs of M4 DIN 985 nuts.
• 1/4 or 3/8 bolt by your choice, at least 20mm long (depends on what ball head you will place on top of the tripod).

I can recommend to use rubber pad bellow the ball head for added friction. Works fine without such as well.
Can take up to 40 mm diameter ball heads.

Print from PETG or stronger material. No supports needed. No hole drilling is needed, if printed properly.

If used with camera, always have in mind that it can brake/fall and damage your equipment - it is strongly recommended that you are looking at your camera and keeping it from falling all the time!