My wife needed something to store and sort out her rhinestones. I made this in tinkercad and added some small 3mmx2mm magnets to keep drawers from falling out when tilted but not so strong to keep from pulling out drawers. 

No supports needed to print.

Each drawer has a lip to keep it from falling out when pulled out. Just tilt up slightly to remove.

drawer measures 76.75mm x 46.5mm interior and 89.75mm (L) x 48.25mm (W) x 28.5mm (H) outer.

they fit nicely within its slot with very little play but enough for a smooth glide.

I removed to holes for wall mounting due to the drawers needing to touch the back wall for magnets to hold. I'll revisit it when i can figure out how to add them back without having to use supports to print.

Printed on Bambu Lab P1P with Bambu basic PLA settings at 0.2 layer height. I did not change any settings.

I was able to fit 10 drawers on the Bambu P1P build plate at one time. (256x256)