base.stl and top.stl printed 10% infill

top.stl print it with the letters down to the bed no supports needed

for the base.stl supports only in the middle the other overhang sections dont need support use support blockers as in picture below

tab.stl(print x4) at 100% infill glue to the top part

used a 9x32 mm spring (uncompressed)

it can fit a push button this type and use its washer from below the base to fix the push button to the base [https://vm.tiktok.com/ZM6nmHBVx/](https://vm.tiktok.com/ZM6nmHBVx/)

This is the button secured inside the base

The cables of the push button come out under the base like this

The spring inside the top part