This is a infinitely expandable string art board. It was designed specifically for string art but it can be used for multiple things. It was designed so that if you aren't a good aim with a hammer or if children want to play string art this version is easier than the traditional game. Although this version may not make as smooth of curves as you could by nailing a lot of nails on a close turn in the traditional version, you can make curves on this to. If you want to make wall art out of it I would recommend gluing the pegs in. If you aren't going for something that you can hang on the wall you can leave the pegs just pushed in so you can change it often. if you would like you could play it as a game to see who could make the coolest design out of a regulate amount of pegs. As you can see in the pictures I just started on the word Prusa. Also notice the edge pieces, you can use these to create a frame around your art.

As far as printing info.

Filament: Prusament Jet Black

Nozzle: 0.4mm

Layer Height: 0.2 this is somewhat crucial to the pegs fitting right.

Printer: I used the i3 Mk3s+ but the Mini will work fine.

Infill: 5% worked good for me but it isn't very crucial. 

Shell : 3

Prep: not much unless your filament strings.

Supports: N/A  -yea, I hate supports!!

Tips: Be sure to enjoy, and don't forget to be creative😉.*

*That's the point of a printer right??