This is a fully 3D printable stand for hanging and displaying key-chains or other things that can hook onto the stand. 

Everything is printed in PLA with a 0.4 mm nozzle at 0.2 mm layer height with 2 perimeters, except the hooks which had 3 perimeters

I recommend printing the hooks with ironing turned on, then they come out looking nicer. However I do not recommend using ironing on the other parts as that can decrease the strength of the snaps.

The stem will need a brim to keep it stable during printing. And the hat can be printed round side facing the build plate with supports turned on. The foot does not need any supports.

After everything is printed the hooks slot into the stem and it should be done.

The tree can be stacked. I've personally tried 2 layers and it was stable but I thing 3 might work fine. If the tree is too wobbly for, you can glue all of the layers together, but then they won't spin :/