I liked the way the original model fit the t-track, but instead of a stop block I wanted a sliding toggle clamp to hold down the work piece. The two parts should work well together for secure/repeatable cuts.

Printing Tips

I printed with the top facing down. This works great except the inset may have long-ish bridges if unsupported. I added snug supports there, but it may not be needed. Also I used 3 perimeters and 20% gyroid infill in PETG for a strong part.

Hardware

Toggle Clamps: [https://a.co/d/aoacPtM](https://a.co/d/aoacPtM)

Screws (non-countersunk screws may be better): [https://a.co/d/6ok9XXq](https://a.co/d/6ok9XXq)

T-track Knobs (you may prefer standard t-bolts): [https://a.co/d/6pqZKDN](https://a.co/d/6pqZKDN)