A remix of the Rocktopus by UNION3DPRINTING. Improved quality over the original Rocktopus. I've smoothed out the seams between where the head and body connects, resulting in a better looking print.

Supports are recommended under the chin. The hole in the body prints fine without supports, but for a clean print I recommend them. Supports aren't needed for the arms.

The print should stick fine to a heated build plate, so no brim in required. If you do decide to print with a brim, then good luck cleaning your print up!

Print recommendations:

 .2 mm layer height

15% infill or higher

Brim: No

Rafts: No

Skirt: Doesn't matter.