Since there are obstacles under my desk and the drawer size is limited, common drawers cannot be fully opened and are inconvenient to use. I designed this drawer that can be fully opened.

There are 2 trays with a total of 5 parts that need to be printed.

Size:226x140x72mm

If you need other sizes, you can contact me

Notes:

1、On the middle slide rail, there are two “Brim” , these “Brim” are cube with a height of one layer，and is very easy to tear off. If you don’t need it, you can also split object  in the  software and delete them(or download file: mid.stl). 

2、The drawer box needs support，support type recommends using the manual method to add support surfaces instead of the auto method(this .3mf has already been setup), and  recommended to use specialized support filament as support  interface.

3、Once the drawer is assembled, install it under the table using double-sided tape（width：3cm）It is recommended to hold the box and stick it under the table as shown in the picture instead of holding the slide rails on both sides to prevent the gap between the slide and rail from being too small and affecting the smoothness.