Simple clip for putting on your table edge and holding the cables. Use self adhesive tape 20mm wide.

Step file is a clip with one slot! However, if you want more slots like below photo. Keep on reading…

Easy to create multiple slots in slicer by putting them side by side:

1. Right click part on the right side bar like the screenshot below (or directly on bed). “Add part” and load the step file again.
2. Select new part and use “Part manipulation”. Change coordinates to part. Move it 20mm so it is side by side by the existing part, see screenshot.
3. Repeat how many you like.

In the 3MF file I have already put three pieces side by side for making it simpler. Note! Only one of them is “active” though. So if you slice the 3MF as it is you get one slot.

To enable the second and third part you have to select the part and “Change type” to “part”. I had it as “Negative volume" as default.