Storm Planter Trooper Thicker

This is a remix of Taboy's Storm Planter Helmet

I dropped the original STL into Meshmixer and extruded the inner wall by one more line thickness (.042mm) making it just a little more sturdy. I printed it with the crappiest white PLA I had and it printed without internal supports and minimal boogers, looks pretty decent. With a .2 layer and 50mm/s it takes under 12 hours to print from the original 8.5 hours. I'm still learning Meshmixer and for the life of me I could not figure out how to keep the file size down.

Print Settings

Printer Brand:

Anet

Printer:

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

Infill:

20%

Filament: Any PLA+ or something sturdy / UV resistant / heat resistant White

Notes:

In Cura it will throw an error saying there are extraneous layers but it did print successfully. Just check the preview and make sure "print thin walls" is checked.

I always print with 3 layers to avoid and infill showing through and that seems to work well.

You should be able to print using a .6mm nozzle with close to a .6 line width. The details may suffer but it should still be pretty strong.

Category: Outdoor & Garden

Descrição

Print Settings