Kids love bubbles! These models are for basic bubble wands that have been kid tested and kid approved.

This is a basic model for a bubble wand, nothing fancy. This print doesn't use a lot of material and prints quickly. Intended as a practical print.

One model includes an extra long version that is suitable for dipping into larger refill containers for bubbles.

The model is designed to print flat, but have lots of grooves on the top side. These groves allow additional bubble solution to be stored making it easier to blow more bubbles.

Print Settings

Rafts:

No

Supports:

Resolution:

0.2 mm

Infill:

Notes:

This model was designed to be printed so slicing it correctly will give best results.

• The layer height should be 0.2 mm, but other heights will likely work
• Printed with a 0.4 mm nozzle, but set the line width to 0.5 mm. All elements are a multiple of 1 mm in width.
• Print with three shells. The main circle and stick can then be printed entirely with shells for the best performance.
• Use 4 top and 4 bottom layers otherwise 100% infill is required. The only portion that is not shells is the circle on the handle.

Category: Toys & Games