There are a few trash cans out there. I though i'd make my own.

Printing

Print the Trash Can right side up in "Vase Mode" with a Extrusion Width of .8mm with a .4mm nozzle diameter

For the Lid print right side up with strips drawn with the  “Paint-On supports” tool (Organic). Make sure the supports are perpendicular to the 1st layer lines on the large flat bottom layer on the lid see image to right. This minimizes the support material and also makes the supports easier to remove.
 

Filament - PLA or PETG is fine

Infill - 15%

Layer Height - 

Trash Can - .30mm in Vase Mode

Lid -  .10mm Detail Mode (The smaller layer thickness reduces the visibility of the layer lines and shows more detail) 

Supports - See my comments above about supports for the Lid

Parimeters - 3 for Lid

Additional Parts - None

Bed Adhesion - You may want some glue stick to ensure good bed adhesion. 

Rafts - None

Scaling - Maybe, but I have not tried it, but if you do scale us your print , let me know how it goes.

Filament Change - None

Post Printing Notes:  None

Happy Printing!

You can help
To help cover the cost of prototyping and sharing models, please consider a donation by purchasing an item from my Amazon wishlist.

Or use this LINK to buy me coffee

Please leave a comment if you print this model and let me know how you like it. 

Here are my other similar models related to Household

printables search – Household @HandyHandcrafts

Also, if you like this model, check out my other models over here:

[https://www.printables.com/@HandyHandcrafts/models](https://www.printables.com/@HandyHandcrafts/models)

Award winning Model “Japanese Toolbox” for the "Box Contest: here:

[https://www.printables.com/model/260100-japanese-toolbox-inspired-locking-lid-box](https://www.printables.com/model/260100-japanese-toolbox-inspired-locking-lid-box)