This is a case with snap-on lid for a single deck of standard size playing cards.

It is the same design as my other two deck model, just reduced in height for single deck: Playing Card Holder for 2 Stacked Decks

Printing Tips

• This is a simple easy print. Any regular printing profile should work. I used PrusaSlicer 0.2mm SPEED with input shaper.
• Use 3 perimeters for extra strength.
• Octagram Spiral as top infill pattern gives an interesting symmetric texture on this model.

I have a remix for smaller sized cards (56 x 87 mm): [https://www.printables.com/model/762940-bridge-playing-card-holder](https://www.printables.com/model/762940-bridge-playing-card-holder)