It can be mounted with screws by the top handle or with double-sided tape.

• Doesn't need supports if you can deal with the overhang;
• Prints well with bigger layers like 0.28 or 0.32;
• I printed in PLA;
• When mounted with screws, be cautious not to put to much stress on top or could break the top handle. 
• Mounted with double-sided tape is better or with both.

If you want to support my work, check out the other models i upload at my page on Cults 3D !!

If you want to support my work and help me feed my three cats, you can also help me here!!