Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Note: Tolerances are VERY tight, screws are not required to snap the Pi into place. You do not need any other equipment.
Once the Pi is set, you can snap the lid into place. It is recommended to put the SD card in after the Pi is set in the base just to make installation much easier.
The screw holes are 1.3 mm diameter.
This is my first 3D model, any feedback is appreciated!
6
Curtidas
214
Downloads
1
Impressões
Categoria
Electronics
Tags
raspberrypi
raspberrypicase
raspberrypi4
Licença
GNU General Public License v3.0
Arquivos (2)
Bottom.stl
235.6 KB
Top.stl
266.9 KB