Having been running to & fro the office to check on builds these past few week, I decided to utilise a ring indoor camera & so needed a mount. 

I modelled my own to take advantage of the original screws that come fitted to the left hand side corner slot & ensure a perfect fit. 

Version#1 was a little tight on the bottom screw, so its tweaked for the uploaded version#2 :)  

This CCTV mount slips into place to the left hand side chassis slots & is secured via the original button head bolts. The ring mounting bracket that comes with the camera (grey) is fitted to the printed unit via 2x brass inserts (M3 x 7mm) that were in turn heated & pressed home. M3x 15 button head bolts & washers nip it all up & then you slot the camera into position. 

(Whilst my LH side tray (see collection) isn't shown fitted, the V2 bracket gives clearance!)