This is a stand with four angled slots for remote controls.

The slots are 13.5/28/37/37mm deep, and about 46/48/51/56mm wide (rounded down); don't forget to measure the width and thickness of your remotes to make sure they will fit. The wells are 39/48/60/72mm deep, which should be enough for most remotes.

The print takes about 125g of filament (depending on the parameters of course). If you wanted to save about 20g of filament, you could try printing with zero (or lightning) infill. I believe the model would still print, but I haven't tried this; I suspect it probably benefits from a little bit of extra weight.