There's something of  a Mario obsession going on in our house at the moment, every hat has been turned into a Mario cap. Here is a pin on Mario and Luigi And Princess Peach badge so you can do he same.

The badge (Pin) can be made in two parts to secure it with a safety pin on just as a stick on disk.

Print the base in the colour of the surround you want, the badges are 2 colour pints.

Use 0.2mm Layer Height, 0.4 or 0.6 Nozzle works fine, enable ironing if you want.

Start with white filament and then make a layer change at 0.8mm for the Mario and Luigi badges.

The princess peach crown in in multiple 0.4mm steps 

0-0.6mm White

0.8mm Yellow

1.2mm Blue

1.6mm Red

Logos were copied from [https://www.mariowiki.com/Emblem](https://www.mariowiki.com/Emblem)