Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
You can glue two 10 x 1.5 mm round magnets in the base.
Print instructions
Recommended infill angle: 0°
Color changes: White -> Black -> Gold
Low speed and high temperature will create a shiny top surface.
There are "holes" inside the model to make some of the top layers more uniform, and they were created with 0.2 layer height in mind.
If your top surface is not flat & shiny and you see scarring, then make sure to check this guide: [https://bit.ly/2UtN0I1](https://bit.ly/2UtN0I1)
Mass Effect Normandy SR-2 Manget
Publicado em 14 de abr de 2019
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta