USB A holder for a 1X1 Gridfinity. Holds up to 8 USB drives. Spacing is wide enough to hold most flash drives or adapters. Designed this to replace my old non-gridfinity holder that I have used for many years. 

Slight taper in the pockets, to help lock in the USB devices when inserted. Slightly oversized for a snug fit, without being too tight. 

Print with the gridfinity base down. I normally use supports for the magnet holes. Any layer height should work, I use 0.2mm. 

Need USB C instead? Check this out: [https://www.printables.com/model/661208-gridfinity-usb-c-holder](https://www.printables.com/model/661208-gridfinity-usb-c-holder)

Need USB A & USB C? Check this out: [https://www.printables.com/model/661214-gridfinity-usb-ac-holder](https://www.printables.com/model/661214-gridfinity-usb-ac-holder)