Print your own clone army!

By request of another Printables user, here's a Clone Trooper (Phase 1) skin for Soozafone's fantastic Mini 13 armature. 

The helmet is partially based on and remodeled from a model by Marr Velz on Sketchfab. Additional modeling has been done to optimize for printing and to adapt it to the Mini 13 armature.

The print in the pictures has been slightly sloppily painted (sorry) with a permanent marker to add the black details. 

Main parts:

• Head/Helmet
• Shoulder (print two of these) 
• Chest
• Waist
• Thighs/Upper legs (left and right. they are similar, but mirrored)
• Shins/Lower legs (print two of these)

Accessories/Optional:

• If you need a blaster, download it from my Stormtrooper here:
  [https://www.printables.com/model/445803-mini-13-stormtrooper](https://www.printables.com/model/445803-mini-13-stormtrooper)

No supports needed. Parts should be printed at 0.15mm. Optionally print the head at 0.1mm for best details.

The rest of the parts are found in Soozafone's Mini 13 Model here:
[https://www.printables.com/model/422353-mini-13-printable-jointed-figure](https://www.printables.com/model/422353-mini-13-printable-jointed-figure)

You will need to print the following pieces from this:

• All the frame pieces in mini13-all-frame.stl
• 2 × mini13-armor-foot-2x.stl
• 2 × mini13-armor-arm-2x.stl

Gcode for the Mini+ included for timing and so on, but slice your own for best results.

Credit: This work is based on "Clone Trooper Phase1 (Shiny) [Updated]" (https://skfb.ly/6Sy7F) by Marr Velz is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).