5 Colour E.T clock, made using Bambu filaments.

(I recommend the following max speed settings, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm

Filaments Used:
PLA Bambu PLA Matte Charcoal (Black) Transmission Distance: 0.6
PLA Bambu PLA Matte Marine Blue Transmission Distance: 2
PLA Bambu PLA Matte Ice Blue Transmission Distance: 3.5
PLA Bambu PLA Basic Jade White Transmission Distance: 5

PLA Bambu PLA Matte Lilac Purple Transmission Distance: 2

Swap Instructions:
Start with Charcoal (Black)
At layer #11 (0.64mm) swap to Marine Blue
At layer #18 (0.92mm) swap to Ice Blue
At layer #23 (1.12mm) swap to Jade White
At Layer #34 (1.56mm) swap to Charcoal (Black) for the border
At Layer #39 (1.76mm) swap to Lilac Purple for the numbers

I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results

Use the exact numbers in your slicer to match up properly.

The Model is designed to print with 0.4 nozzle.

**If re-scaling model make sure not to alter the Z height of the model**

add a negative cylinder to the Centre of the clock in the slicer to create the correct size hole for your movement or alternatively drill the required size hole.

Link for the movement that I used is listed below but any standard movement will be fine (be sure to check the size of the hands)

[https://www.amazon.co.uk/dp/B0BBLXG55S?psc=1&ref=ppx_yo2ov_dt_b_product_details](https://www.amazon.co.uk/dp/B0BBLXG55S?psc=1&ref=ppx_yo2ov_dt_b_product_details)

ALL of Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.